Ethtool driver bnx2

Facts: On all nodes, both Broadcom ports and one Intel port are connected to the same switch. - UPDATE: Link loss is detected on ports on both NICs, Broadcom and Intel. - All ports are at Gb/s speed, except the Intel ports on two of the nodes, which are at Mb/s speed. All speeds set using auto-negotiation.  · How do I update all crucial elements like LifeController, BIOS, NIC drivers, etc on R running Centos 7? I am trying OMSA. [root@vps ~]# ethtool -i em1 driver: bnx2 version: firmware-version: bc NCSI expansion-rom-version: bus-info: supports-statistics: yes supports-test: yes supports-eeprom-access: yes . We don't have this kind of behaviour with be2net driver which is the second network interface in the bonding configuration. Is there any known regression on RedHat or CentOS with this driver? There is something strange in the ethtool output for the network interface which use the bnx2 driver, the port is listed as "FIBRE".Product Version:

The Ethernet driver settings and auto-negotiation can be checked with the following commands: # ethtool -i eth0 driver: bnx2 version: suse firmware-version: bus-info: [root@localhost ~]# ethtool –a eth0 Pause parameters for eth0: Autonegotiate: on RX: on TX: on. # ethtool -i eth0 driver: bnx2 version: suse firmware-version: bus-info: 5. Display Auto-negotiation, RX and TX of eth0. View the autonegotiation details about the specific ethernet device as shown below. # ethtool -a eth0 Pause parameters for eth0: Autonegotiate: on RX: on TX: on 6. - 1 on-board 2-port Broadcom NetXtreme II BCM Gigabit Ethernet (rev 12) (using bnx2 driver) - 1 4-port Intel EB Gigabit Ethernet Controller (Copper) (rev 06) (using ee driver) Facts: On all nodes, both Broadcom ports and one Intel port are connected to the same switch.

The ethtool program talks to device drivers by using the ioctl system call. The ethtool functions are installed in the bnx2 driver in a. Kartu ethernet adalah Broadcom netXtreme II BCM dan driver yang digunakan adalah: b $ ethtool -i eth1 driver: bnx2 version: firmware-version. Checking with ethtool the active interface gave me the following: Load the bnx2 driver again with disabled MSI.